TM 9-2330-285-14&P/TO 36A11-21-10-1
STEERING KNUCKLES - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION
a. Place steering knuckle (1) and thrust
10 Axle beam
Steering knuckle
washer (2) in position on axle beam (4).
(1), thrust
b. Put in kingpin (3).
washer (2) and
Make sure flat on kingpin is alined
kingpin (3)
to setscrew.
a. Using 5/32-inch socket head wrench, screw
Setscrew (5)
11 Steering knuckle
in setscrew (5) and tighten.
and nut (6)
b. Using 1/2-inch box wrench, screw in nut
(6) and tighten,
Position plate (8) and gasket (7) on top of
Gasket (7), plate
12 Steering knuckle,
knuckle and secure with two screws (10) using
(8), two washers
top side
a 5/32-inch socket head wrench.
(9) and two
screws (10)
Position plate (12) and gasket (11) on bottom
Gasket (11), plate
13 Steering knuckle,
of knuckle and secure with two screws (14)
(12), two washers
bottom side
using a 5/32-inch socket head wrench.
(13) and two
screws (14)
TA 221695
