TM 9-2330-285-14&P/TO 36A11-21-10-1
HYDRAULIC BRAKE LINES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
TUBE REMOVAL - REAR DOLLY
NOTE
This is a typical procedure for the left or right side
brakes.
For late model dolly sets there is no left side brake tube.
There are two clamps holding the right side tube.
For early model dolly sets there are two clamps on the right
side brake tube. There are no clamps holding the left side
tube.
Step 9 applies only to late models, right side.
Ten wire ties (2)
Cut off using cutting pliers.
9 Brake tube (1)
10 Master cylinder (3)
Tube (4)
Disconnect using a 7/16-inch wrench.
11 Axle beam (5)
Clamps (6),
Take off using a cross-tip screwdriver (if
screws (7) and
applicable).
washers (8)
