TM 9-2330-285-14&P/TO 36A11-21-10-1
HYDRAULIC BRAKE LINES - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
BLEED BRAKES - PRESSURE BLEEDER
NOTE
This procedure should be used whenever a pressure bleeder
unit is available. If this unit is unavailable, bleed brakes
This procedure is typical of both the front and rear dollies.
For specific instructions for operation of the pressure
bleeder refer to applicable operator's instructions.
Remove using 5/8- and 1-inch wrenches.
Cap (2)
Master cylinder (1)
28
Attach to master cylinder (1).
Adapter (3)
Pressure bleeder
29
Tank (4)
a. Check or add brake fluid.
30
b. Pressurize to 10 to 20 psi (13.6 to
27.1 Nm).
NOTE
Bleed the brake assembly which is furthest from the master
cylinder first.
a. Open by turning 1/2 to 3/4 turn counter-
Bleeder screw (6)
31
Brake assembly (5)
clockwise using a 7/16-inch wrench.
b. Leave open until there are no air bubbles
in the brake fluid.
c. When fluid is running as a solid mass,
close the bleeder screw.
d. Repeat procedure for the opposite brake
assembly.
Remove pressure.
Tank (4)
32 Pressure bleeder
Remove from master cylinder (1).
Adapter (3)
33
Install using l-inch and 5/8-inch wrenches.
Cap (2)
34 Master cylinder (1)