TM 9-2330-287-14&P
OPERATION IN SALTWATER AREAS
Saltwater will cause rapid rust and corrosion to develop. Clean, Inspect, and lubricate more often
than scheduled.
OPERATION IN MUD
Thoroughly clean and lubricate all parts contaminated by mud as soon as possible after operating in
FORDING
1. Check bottom surface of stream or river. if bottom surface is too soft, do not ford.
2. Protect cables, connectors, and terminals by spraying them with ignition insulation compound.
3. After fording, apply the brakes a few times to help dry out the brake lining. Be sure brakes are
operating properly before driving at normal speeds.
4. Lubricate all unpainted surfaces with lubricating oil.
5. Lubricate the trailer in accordance with the lubrication chart, page 4-3.
6. Refer to TM 9-238 for deepwater fording information.
Section V. OPERATION OF MATERIEL IN CONJUNCTION WITH
T H E BOLSTER TRAILER
Page
Page
Preparation for Loading . . . . . . . . . . . . . . . . . . . . . .2-23
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-21
Uneven Length Loads . . . . . . . . . . . . . . . . . . . . .2-22
Loading . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-24
Partial Loads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -22
2
GENERAL
The invasion pipe retainer kit (1) consists of two metal plates structurally reinforced and welded.
When transporting loads of Invasion pipe on the M796 and M796A1 bolster trailer, these plates are
used in conjunction with the portable bolsters, chain assemblies, straps, load binders, and
stanchions. A normal load for tiedown with the invasion pipe retainer kit consists of 41 lengths of pipe,
6-inch inside diameter by 21 feet long.
TA224762