TM 9-2330-287-14&P
PREPARATION FOR LOADING
1.
Couple trailer to towing vehicle as described in section Ill, page 2-14.
CAUTION
Airhoses and electrical harness must be disconnected from the rear of the reach tube
before extending or retracting it. If not, damage to trailer could result.
2.
Set handbrake, disconnect airhoses and electrical harness from rear of reach tube (1), and
remove center pin (2) to unlock reach tube (1).
3 . By moving towing vehicle very slowly, extend or retract reach tube (1) as required to permit
centering weight of the load over the center tiedown ring. Aline center pin holes and
insert center pin (2), locking reach tube (1).
4 . Remove four portable bolsters (3) from their stowed position in bed of trailer.
5 . Remove four stanchions (4) from stowed position in reach tube area of frame.
6 . Remove four load binders, four tiedown chains, and three straps from storage compartment (5).
7 . Place the invasion pipe retainer kit clear of loading area to prevent possible damage.
TA224764
