TM 9-2330-287-14&P
REAR SECTION WIRE HARNESS - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
Disconnect.
Rear section wire
3. Reach tube,
rear (1)
harness (2)
NOTE
Prior to disconnecting mated connectors, note numbers on identification bands. If
numbers are not legible or identification bands are missing, tag wires with proper
identification numbers.
Remove and separate.
Four mated
4. Clip
connectors (4)
assemblies (3)
Using screwdriver, remove.
Six screws (6) and
5. Six clamps (5)
ground wire (7)
Remove.
Six clamps (5)
6. Rear section
wire harness (2)
Remove tape holding harness to airhoses,
Tape wrapping (8)
7.
if installed.
Remove.
Rear section wire
8. Trailer frame,
rear (9)
harness (2)
INSTALLATION
Place in position.
Rear section wire
9. Trailer frame,
rear (9)
harness (2)
Reconnect and remove identification tags.
Four mated
10.
connectors (4)
Install.
Four mated
11. Clip
connectors (4)
assemblies (3)
12. Rear section wire
Position on harness (2).
Six clamps (5)
harness (2)
Position, alining mounting holes.
Six clamps (5) and
13. Trailer frame,
rear (9)
ground wire (7)
Using screwdriver, install.
Six screws (6)
14. Six clamps (5)
Tape to airhoses.
Tape wrapping (8)
15. Rear section wire
harness (2)
