TM 9-2330-287-14&P
REACH TUBE SECTION WIRE HARNESS - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
Pull back on quick disconnect fittings (2)
Two quick disconnect
1. Reach tube,
fittings (2)
and unhook.
rear (1)
Disconnect.
Rear section wire
2.
harness (3)
Using wrench, remove.
Jamnut (5)
3. Receptacle (4)
Using socket and handle, remove.
Four capscrews (7)
4. Plate (6)
and four
Iockwashers (8)
NOTE
Step 5 applies to M796A1 trailer only.
Remove.
Antirotation
5.
bracket (9)
Remove.
Plate (6)
6. Reach tube,
rear (1)
Tie rope (11) to harness.
Reach tube section
7. Receptacle (4)
wire harness (10)
NOTE
When removing wire harness, leave sufficient length of rope exposed at both ends of
reach tube. Rope will be used for installation of new harness.
a. Pull harness (10) out of reach tube.
Reach tube section
8. Reach tube,
b. Untie rope (11).
wire harness (10)
front (12)
INSTALLATION
Tie rope (11) to harness (10) forward of
Reach tube section
9. Rope(11)
receptacle (4).
wire harness (10)
Pull rope (11), drawing harness (10) into
Rope (11)
10. Reach tube,
reach tube.
rear (1)
Untie.
Rope (11)
11. Reach tube section
wire harness (10)