TM9-2330-287-14&P
HANDBRAKE CABLE - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE: Install hub and drum (page 4-87).
TASK ENDS HERE
HANDBRAKE CABLE ADJUSTMENT
This task covers:
Adjustment
INITIAL SETUP
Equipment Condition
Tools
Service brakes adjusted (page 4-50).
Jack
Wrench, open-end, adjustable
Wrench, open-end, 9/16-inch (two
required)
ACTION
ITEM
LOCATION
REMARKS
NOTE
Procedure is for one handbrake. Repeat procedure for opposite side.
Jack (2)
Place jack (2) under front wheel axle (1)
1. Front wheel axle (1)
and raise until wheel (3) clears ground.
Handbrake lever(5)
Release (unlock).
2. Trailer frame,
front (4)
Knob (6)
Turn knob (6) in the necessary direction
3. Handbrake lever(5)
to position link pin (7) approximately
halfway between each end of slot (8).
Two jamnuts (10)
Using two 9/16-inch wrenches (one on jam-
4. Turnbuckle (9)
nut and one on turnbuckle), loosen.
