TM 9-2330-287-14&P
SPARE WHEEL STORAGE ASSEMBLY- CONTINUED
ACTION
ITEM
REMARKS
LOCATION
ASSEMBLY CONTINUED
Shaft (2) and two
Insert shaft (2) through frame (1).
11. Frame (1)
flanges (3)
Install flanges (3) on shaft (2) with
flat sides facing each other.
Shaft (2), washer
Install shaft (2) in bracket (4).
12. Bracket (4)
(5), and cotter
Using pliers, install washer(5) and
pin (6)
cotter pin (6) on shaft.
Position flanges (3) with flat sides
Flanges (3) and
13. Shaft (2)
alined with inside edge of cable
two setscrews (7)
guide (8).
Using socket-head wrench, tighten
setscrews (9).
Install cable (10) through guide (8) and
14.
Cable (10), U-bolt
thread through shaft (2).
(11), and two
Using 7/16-inch socket and handle, in-
nuts (12)
stall U-bolt (11) and nuts (12), clamp-
ing cable (10) to shaft (2).
Pass cable (10) through member (13)
15. Member (13)
Cable (10), U-bolt
and between clip (15) and U-bolt (14).
(14), clip (15),
Using 7/16-inch socket and handle, in-
and two nuts (16)
stall U-bolt (14) and nuts (16).
NOTE
FOLLOW-ON MAINTENANCE: Install spare wheel (page 3-7).
TASK ENDS HERE
TA224831
4-102
