TM 9-2330-294-14
Figure 4-11. Retractable clearance light housing assembly (semitrailer No. 201 and on ).
remove lamp, socket and wiring assembly and
gasket. Install door and lens on socket and wiring
Assembly Repair
(fig. 4-12 or 4-13)
assembly and secure with two screws removed in (4)
above.
a. Disassembly. Remove retractable clearance
(6) For semitrailer No. 1 through 200 repeat (4)
light housing assembly by following procedure in
and (5) above for blackout light.
paragraph 4-20a above.
(7) If housing or wiring harness is damaged,
(1) Remove four screws, lockwashers and
remove wiring harness by pulling from housing.
washers securing plate to housing.
b. Repair. Clean plate and housing with dry
(2) Disconnect light assembly wiring harness
cleaning solvent type 11 (SD-2). Inspect plate and
connector(s).
housing for cracks, bends or other damage and
(3) Remove nut, two lockwashers and screw
replace if necessary. Repair marker light in ac-
securing wiring harness clamp and ground wire to
cordance with paragraph 4-22. Repair wiring harness
plate.
per paragraph 4-23b.
(4) Remove two screws securing clearance light
c. Assembly. Assemble in reverse order of
door and remove door and lens.
disassembly (a above). Install retractable clearance
(5) Remove four screws and lockwashers
light housing assembly by following procedure in
securing socket and wiring assembly to plate and
