TM 9-2330-297-14&P
LANDING GEAR LEG - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
21.
Chassis frame
Landing gear
a. Slide landing gear leg (1) on cross-
leg (1) and
shaft (3) part way.
pinion gear (2)
b. Place pinion gear (2) on cross-shaft (3)
and slide landing gear leg (1) onto
cross-shaft (3).
22.
Leg mounting
Using 3/4-inch socket wrench, install
bracket (4)
bracket (4), capscrews (5), washers (6),
and nuts (7).
23.
Landing gear
Support (8), bolt
a. Position support (8) at leg (1).
leg
(9), spacer (10)
b. Using 15/16-inch socket wrench, install
and nut (11)
bolt (9), spacer (10), and nut (11).
24.
Lateral support
a. Position support (12) at leg (1).
(12), bolt (13)
b. Using 15116-inch socket and wrench,
and nut (14)
install bolt (13) and nut (14).
25.
Groove pin (15),
a. Adjust legs the same length.
pinion gear (2)
b. Aline holes in cross-shaft (3) and
and cover (16)
pinion gear (2).
c. Using hammer and punch, install groove
pin (15).
d. Pack gear cavity with GAA grease.
e. Using screwdriver, secure cover (16)
with screws (17).
f. Using hammer, Install plug (18).
26.
Landing gear
Perform operational check.
leg (1)
a. Raise landing gear leg (1).
See page 2-16.
b. Lower landing gear leg (1).
See page 2-35.
27.
Jack stands (19)
a. Using landing gear legs (1), raise
chassis frame off jack stands (19).
b. Remove jack stands (19)
28.
Left and right
Wheel chocks (20)
Remove four wheel chocks (20).
wheels
4-90
