TM 9-2330-297-14&P
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
18.
Crank handle (3)
a. Place handle (3) on cross-shaft (1).
b. Using 9/16-inch socket and 9/16-inch
wrench, install bolt (4), washers (5),
and nut (6).
19.
Landing gear
Perform operational check.
legs (2)
a. Raise landing gear legs (2).
b. Lower landing gear legs (2).
20.
Rear axle
Jack stands
a. Using landing gear legs (2), raise
(7) and wheel
chassis frame off jack stands (7).
chocks (8)
b. Remove jack stands (7).
c. Remove wheel chocks (8).
TASK ENDS HERE
Section XII. TORQUE ARM MAINTENANCE
Page
Torque Arm ....................................................................................................................................................... 4-97
TA223169
4-96