TM 9-2330-356-14
(c) Remove the three marker lights
(j) Connect right center marker light lead
para 4-15) from the triple marker box,
but do
not remove
to the lead assembly. Replace gasket and cover. Secure
the washer and shell from the light leads.
with four screws.
(k) In the left marker box, connect the two
(d) Pull old wire lead through conduit and
harness leads (No. 21-489) to the new lead assembly.
out through one of the openings in the triple marker box.
Connect the left marker light lead (No. 489) to the lead
assembly. Replace gasket and cover. Secure with four
(e) Starting at left composite light box,
screws.
thread a lacing wire through conduit into triple light box.
Attach lacing wire to lead, and pull lead through conduit
(l) Test operation of lights.
into composite light box.
(4) Front Marker Light Lead Assemblies Replace-
(f) Install new terminal onto lead. Connect
ment.
triple marker light lead assembly to connector lead
(a) Remove both front marker light box
covers and gaskets (fig. 4-21) by removing eight screws
from each box cover and disconnecting the marker light
(g) Replace composite light box cover and
electrical lead (No. 489).
gasket. Secure with six screws.
(b) Remove six screws from the front
(h) Connect the marker light leads to the
triple marker light lead assembly.
gasket.
(j) Test operation of lights.
(3) Right Side Marker Light Lead Assembly Re-
placement.
(a) Remove four screws that secure right
(b) Disconnect the marker light lead from
the right center marker light lead assembly, then remove
the cover and gasket.
(c) Cut the terminal from the marker light
lead assembly.
(d) Remove the four screws that secure left
side marker light box cover to the light box. Remove cover
and gasket.
(e) Disconnect the marker light lead and
TA502342
remove gasket and cover.
(f) Disconnect the marker light lead
(c) From inside electrical access hole,
assembly from the two wire harness leads.
disconnect the left marker light lead assembly from the
right marker light lead assembly. Disconnect right marker
(g) Pull the old marker light lead assembly
light lead assembly from receptacle wire lead (No. 21-489)
through the conduit and out the left marker light box.
and wire harness lead (No. 21-489).
(h) Thread a lacing wire through conduit
(d) Cut the terminal from the right marker
from one light box to the other. Attach lead assembly to
light lead assembly in the right marker box.
lacing wire and pull the lead into the right marker box.
(e) From inside the left marker light box,
pull the old right marker light lead assembly from the
(i) Install new terminal onto the lead
conduit.
assembly.