TM 9-2330-356-14
TA502360
b. Throttle Cable Adjustment.
(4) Remove inside jam nut and pull cable through
shrouding.
NOTE
(5) Remove screw and handle from cable
Engine should be adjusted to low idle speed
(900 rpm).
(6) Remove packing nut, jam nut, and washer.
(1) Remove engine panel door by loosening the
(7) Pull cable through channel of control panel.
two retaining screws (fig. 4-101) and lifting door out.
(8) Cut and remove straps that support cable.
(2) Start engine (para 2-10).
Remove cable.
(9)
(3) To increase engine speed, loosen the throttle
jam nut on the outside of the panel and tighten the inside
jam nut (fig. 4-107).
(4) To decrease engine speed, loosen the inside
jam nut and tighten the outside jam nut.
(5) Shut off engine (para 2-10).
(6) Replace engine panel door.
c. Removal.
(1) Remove engine panel door by loosening the
two retaining screws (fig. 4-101) and lifting door out.
(2) Remove clevis pin and cotter pin (fig. 4-107)
from end of throttle cable. Disconnect throttle cable from
throttle rod.
TA099848
(3) Remove yoke and jam nut from end of
Control Panel.
throttle cable.
