TM 9-2330-356-14
Check crankshaft end play (fig. 7-35). Use
g.
enough rear bearing plate shims (23, fig. 7-27) to provide
0.010- to 0.015-inch end play. If more than 0.010-inch total
thickness is required, use a steel shim of proper thickness
and a 0.005-inch thick gasket on each side of shim. This
avoids excessive gasket compression and maintains bolt
(21). Secure with capserew (36), lockwasher (37), and two
flat head screws (20).
i. Install baffle (35) onto backplate (21). Secure with
capscrew (18) and lockwasher (19).
j. Install starter and mounting bracket (34) onto
backplate (21) with three capscrews (32) and lockwashers
(33).
7-29
