Figure 7-40. Cylinder Head Bolt Tightening Sequence

TM 9-2330-356-14

TA100112

Figure 7-40. Cylinder Head Bolt Tightening Sequence.

Install retaining flange (3), and tighten down with

g. Connect flexible fuel inlet line to pump inlet.

screws (1) and washers (2).

Connect fuel return line.

Reconnect fuel lines (para 7-55).

Connect each fuel outlet line to the proper pump

outlet (para 4-73 and 7-55)

Flywheel Assembly (Fig. 7-22)

Connect governor linkage to governor arm.

a. Mount ring gear (5), flywheel (3), and hub (4) to

j. Start and run engine. Adjust governor linkage if

crankshaft using screw (1) and washer (2).

Install blower housing (para 7-60).

7-48. Fuel Injection Pump (Fig. 7-21 )

a. Tune engine flywheel to the port closing mark

(PC) on the front cylinder (closest to blower wheel)

compression stroke (fig. 7-78).

If new injection pump is being installed, remove

timing hole screw located on pump mounting flange

(fig. 7-41). Insert a 1/8-inch diameter wire into the hole.

Rotate pump face gear until wire slips into place,

locking the gear in position.

Mount pump on crankcase (fig. 7-21), ensuring

that shims (5) are in place, and secure in position using

four hexagon nuts (2), flatwashers (4), and lockwashers

(3). If O-ring seal between pump and crankcase is worn,

cracked, or otherwise defective, replace it.

Remove wire. Install timing hole screw and

copper gasket.

TA100113

Figure 7-41. Injection Pump Installation.

Time injection pump (para 7-86).