TM 9-2330-357-14&P
5-10. FIFTH WHEEL KINGPIN REPLACEMENT (Con't).
b.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear
protective goggles and gloves, and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent's flash point
is 100 -138 (38 -59 ). If you become dizzy while using cleaning
F
F
C
C
solvent, immediately get fresh air and medical help. If solvent contacts
eyes, Immediately wash your eyes and get medical aid.
1.
Remove all buildup of grease or dirt by using a clean rag or wire brush and dry cleaning solvent, and
allow to dry.
2.
Inspect upper fifth wheel kingpin plate for dents, cracks, or deformation.
c.
INSTALLATION
1.
Place fifth wheel kingpin (2) into position.
2.
To center fifth wheel kingpin (2):
(a)
Measure 23.5 in. (59.7 cm) forward from
edge of bearing plate (3).
(b) Measure 26.25 in. (66.68) from side rail
(1).
(c)
Measure 18 in. (45.72 cm) from front
cross-member.
(d) Measure 7 in. (17.78 cm) from cross-
angle support.
WARNING
Always wear protective clothing (gloves, goggles, etc.) when using
cutting, grinding or welding (burning) equipment. Failure to do so could
result in serious injury to personnel
3.
Weld fifth wheel kingpin (2) in place (TM 9-237).
FOLLOW-ON TASKS:
Install access cover (para 4-58).
TA706532
5-25
