TM 9-2330-357-14&P
5-8. TRUNNION AXLE REPAIR (Con't).
b.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear
protective goggles and gloves, and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent's flash point
Is 100 -138 (38 -59 ). If you become dizzy while using cleaning
F
F
C
C
solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
1.
Remove all buildup of grease or dirt by using a clean rag or medium bristle brush and dry cleaning
solvent, and allow to dry.
2.
Inspect for loose, missing, or damaged hardware.
3.
Inspect bearings and cups in accordance with TM 9-214.
c. ASSEMBLY
1.
Install bearing cup (7), bearing (6), retainer (5),
new oil seal (4), two new oil seals (3), new oil
seal (2), and washer (1).
2.
Install bearing cup (16) into spring seat (17).
3.
Install bearing (15), spring seat (17), nut (14),
keywasher (13), and nut (12). Adjust nuts to
allow spring seat to move when 15-20 lb.-ft.
(20-27 N ) of torque is applied.
m
4.
Install new gasket (11), cap (10), six new
5.
Pack assembly with grease through grease
fitting (18).
TA706531
FOLLOW-ON TASKS:
5-22