TM 9-2330-357-14&P
5-11. OUTRIGGER ACTUATOR ASSEMBLY REPAIR (Con't).
17.
Remove key (21).
18.
Place outrigger actuator assembly (2) into
horizontal jig.
CAUTION
DO NOT extend or retract ball screw
subassembly to extreme ends of travel to
keep from turning. Failure to follow this
caution will result in damage to equipment.
19.
Remove lockwire (23) and loosen jamnut (25)
until lockwasher (26) can be disengaged from
slot (22) in ball screw subassembly (27).
Discard lockwire.
NOTE
Keep ball screw subassembly from turning while performing step 20.
20.
Insert bar through hole in rod end (24) and remove rod end by turning counterclockwise.
5-31
