TM 9-2330-357-14&P
5-11. OUTRIGGER ACTUATOR ASSEMBLY REPAIR (Con't).
37.
Place ball screw subassembly (27), with ball nut (29) up, into vertical jig.
CAUTION
To prevent loss of ball bearings, DO NOT rotate ball nut more than 5/8 in.
(1.58 cm) past end face of ball screw. If bearings are removed, replace ball
screw subassembly.
38.
Turn ball nut (29) approximately 5/8 in. (1.58 cm) past end face of ball screw (44) and remove ice
scraper (45) and two ice scraper pins (46) from ball nut.
39.
If damaged, remove lube fitting (47).
5-36
