TM9-2330-358-14&P
ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
Table 4-1.
S--SEMIANNUALLY
Q - QUARTERLY
INTERVAL
ITEM
ITEM TO BE INSPECTED
NO.
S
PROCEDURE: CHECK FOR AND HAVE REPAIRED, FILLED
Q
OR ADJUSTED AS NEEDED
d.
Clean, repack, install and adjust
q
e. Check brakes.
q
4
SPRINGS
WARNING
It is essential that torque values be maintained to
insure proper operation of the suspension system. The
torque values of the suspension bolts and nuts must be
checked after the initial break-in period of 1,000 miles
(1,600 km) and every three months thereafter. Failure to
do so may cause injury to personnel, damage to equipment
and will void the warranty.
a.
Check trunnion cap u-bolts for tightness.
q
lb ft (1192 Nm).
b.
Check spring cap u-bolts for tightness. Torque to 300
q
lb ft (408 Nm).
c.
Check spring cap bolts for tightness.
q
ft (244 Nm).
d.
Check springs for any evidence of damage or sagging.
q
e.
Check for shifted leaves. If evidence of shifting,
q
sagging, or damage exists, immediately notify Direct
Support.
5
DATA PLATES
Replace
q
BODY (FLOOR)
6
Check overall body and floor condition for evidence of
q
rotted wood, gouges and other damage. Repair as
necessary.
4-9