TM 9-2330-371-14&P
SPRING SEAT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
17.
Spring seat
Two Iockwashers (10)
Place into screw holes (12) in spring
assembly (3)
and long screws (11)
seat (3).
Screw in loose, leaving room
between the end of the screws and
the face of the seat.
18.
Trunnion tube
Spring seat (3)
a.
Position end with inner bearing over
shaft (6)
and onto trunnion tube shaft (6).
b.
With rotating motion, slide it back
until seated.
19.
Trunnion tube
Outer
a.
Check to be sure it is properly grease
shaft (6) and
bearing (13)
packed.
spring seat
b. With small tapered end inward, slide it
assembly (3)
over trunnion tube shaft (6), and seat
into spring seat bearing cup.
Trunnion tube
20.
Inner hex
Screw on until just contacting
shaft (6)
nut (14)
bearing (13), but do not tighten.
Make sure small bump on face of hex
nut (14) is facing outward.
TA224336
5-35
