TM 9-2330-371-14&P
SPRING SEAT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REPAIR
CAUTION
Replacement bearings and corresponding bearing
cups are matched sets. Do not mix bearings and
bearing cups. Mixing of bearings can cause early
equipment failure.
12.
Spring seat
Two bearing
a.
Position seat (1) on wood block (4)
assembly (1)
cups (2)
to prevent damage to bore (5) face
areas.
Make sure your hands are clean.
b . Place cupped side up on spring seat
bearing bore (5). Make sure it is
evenly alined all around.
c . Using a bearing cup driver tool and
hammer, drive cup (2) down until
seated.
d . Turn spring seat assembly (1) over and
repeat steps a, b, and c.
INSTALLATION
NOTE
Pack all inner and outer bearings with GAA grease,
using a bearing packer. Make sure that grease has
filled all bearing spaces before you install.
13.
Spring seat
a. Place on wood blocks (4) rear side up
assembly (1)
for installation of inner bearing and
rear seal.
b. Apply a thin coating of GAA grease to
bearing cup raceway (3).
TA224334
