TM9-2330-372-14&P
(3) Remove items (11 and 12), bolts and washer, and item (13) cap, and remove jack from swivel. \par
(4) Remove four screws (30), washers (29), plate (8), shim set (3), base (2), and a-ring (14) from swivel base
(9).
(5) Replace all damaged parts.
(6) Pack swivel base (9) with grease (GAA) prior to installing shims.
NOTE
When installing plate (8) torque screws (30) to 50 lb-ft, using a feeler gage, determine the gap
between base, (item 2, and base item 9). The gap should be .012 inch + .002 which provides an 0-
ring crush, item 14. If the measured gap does not meet the range specified, remove bolts and
lock washes, items 29 and 30 and add or remove shims.
d. Disassemble pin assembly (Item 15, Figure 18) (1034 only).
(1) Remove pin assembly (15) by unscrewing housing (28), washer (27) will come off.
(2) Remove pin (26) from sleeve (23).
(3) Remove pin (22) from sleeve (23).
(4) Remove pin (20) and spring (21) and "0" ring (19).
(5) Replace damaged parts and assemble in reverse order.
(6) Reverse order to assemble swivel and jack. Torque cap screws (31) to 120 lb-ft, and (11) to 120 lb-ft. Do
not torque item 28.
(7) Check for safe operation of jack assembly.
e. Disassemble swivel lock assembly (Item 15, Figure 18) (XM1048 only).
(1) Remove pins (7), swivel pin (8), from housing (6).Apply GAA Grease to swivel pin threads and lock
assembly housing per lub order.
Change 1 4-24
