TM9-2330-372-14&P
(2) Remove gasket (10) between cap (13) and base (9) and discard.
f. Install swivel lock assembly (15) as follows:
(1) Replace gasket (10) between cap (13) and base (9), per figure 18.
(2) Install cap (13).
(3) Install lock washer (27) on housing (16).
(4) Install items (11) and (12) bolts and lock washers, do not tighten.
(5) Install housing (16) and rotate in direction required to provide a gap between cap (13) and base (9), that is
1/16 inch on housing side, crushing neoprene gasket (10).
(6) If holes in housing (16) for roll pins (17) are not parallel with the axis of the jack, rotate housing (16) in a
tightening or loosening direction, as required, until the holes are parallel. This will permit subsequent removal of item
(18) swivel pin for cleaning and lubrication without removal of item (16) housing.
(7) Torque bolts (11) to 120 lb-ft increments. Do not torque housing (16).
(8) Install lock pin (18), hand tight in housing (16).
(9) Install pins (17).
(10) Install jack and swivel assembly on trailer and torque bolts (31) to 120 lb-ft.
(11) Check for safe operation of jack assembly.
(1) Remove four socket head cap screws (34) and cover assembly (29).
(2) Remove bearing cone (33) from gear (27).
(3) Drive out groove pin (26) and remove gear (27).
Change 1 4-25