TM 9-2330-373-14 & P
4-12.
INTERVEHICULAR CABLE RECEPTACLE (cont)
REMOVAL OF 12-VOLT RECEPTACLE
1.
Disconnect power source.
2.
Remove two screws (1) and washers (2) securing receptacle (4). Re- move receptacle.
3.
Loosen screws (3) securing each wire. Tag and
remove wires from rear of receptacle.
INSTALLATION OF 12-VOLT RECEPTACLE
1.
Clean and inspect receptacle in accordance with
the procedure for the 24-volt receptacle (page 4-
40), 2. Insert each wire into its proper position at
rear of receptacle (refer to wiring diagram, page
3.
Position receptacle (4) and secure
1.
Screw
with two screws (1) and washers (2).
2.
Washer
3.
Screw
4.
Connect power source.
4.
Receptacle
MAIN HARNESS RECEPTACLE
REMOVAL
1.
Loosen nut (1) securing dolly harness receptacle
(2) to main harness receptacle (3).
2.
Pull dolly harness receptacle
(2) outward and away from main
1.
Nut
harness receptacle (3) to
2.
Dolly harness
receptacle
separate the two receptacles.
3.
Main harness
receptacle
TA 314763
4-42
