TM 9-2330-373-14 & P
MAIN HARNESS RECEPTACLE (cont)
INSTALLATION
1.
Slide rubber bushing (3) over wires (1).
2.
Solder wires to terminals at rear of receptacle
(refer to wiring diagram, page 4-36).
3.
Slide nut (2) over wires (1) and bushing (3) to
rear of receptacle (4). Tighten nut (2).
1.
Wires
2.
Nut
3.
Bushing
4.
Receptacle
4.
Make certain power source is disconnected and make a continuity check of all circuits throughout semitrailer,
using multimeter.
5.
Wrap exposed wire and nut with tape.
6.
Insert receptacle into hole in chassis.
7.
Aline holes in receptacle plate (4) with holes in
chassis.
8.
Secure receptacle (4) with four screws (3),
washers (2) and nuts (1).
1.
Nut
2.
Washer
3.
Screw
4.
Main harness receptacle
TA 314765
4-44
