TM 9-2330-373-14 & P
MAIN HARNESS RECEPTACLE (cont)
REMOVAL (cont) I
3.
Remove four nuts (1), washers (2) and screws
(3) securing main harness receptacle (4) to
chassis.
1. Nut
3. Screw
2. Washer
4. Main harness receptacle
4.
Remove all tape at rear of receptacle (4) to
expose wires and bushing retainer nut (2).
5.
Remove nut (2) from receptacle (4) and slide nut
back over wiring harness (1).
6.
Remove rubber bushing (3) from receptacle (4)
and slide bush-
ing back over harness (1) to
1.
Harness
expose solder connections.
2.
Nut
3.
Bushing
7.
Mark and unsolder wires at rear
4.
Receptacle
of receptacle (4).
CLEANING AND INSPECTION
WARNING
Cleaning solvent, used to clean parts, is potentially dangerous to personnel and property. Do not upe near
open flame or excessive heat. Flash point of solvent is 158 F (58.80C).
1.
Clean all parts with cleaning solvent (item 3, appendix E).
2.
Inspect for cracks, breaks or other damage.
3.
Replace defective parts.
TA 314764
4-43
