TM9-2330-374-14&P
Installation.
b.
CAUTION
B e sure all grommets are present when installing wiring
harness.
I f grommets are missing, the wiring harness
may be damaged when threading through crossmember.
(1) Install wiring harness by threading through crossmember and grommets.
Remove wire or string used to pull harness through crossmembers.
(2) Connect 12 and 24 volt light connectors and front receptacles. Make sure
band marker numbers match.
(3) Check wiring harness for continuity.
(4) Install seven wire clips on either side of frame rail.
12 VOLT RECEPTACLE
INITIAL SETUP
Tools
General mechanics tool kit
Materials/Parts
12 volt receptacle
WARNING
D i s c o n n e c t all outside power before performing any
Failure to do so
maintenance on the electrical system.
could result in serious injury or death.
Removal.
a.
(1) Remove two nuts, washers and screws that secure 12 volt receptacle to front
crossmember (1, figure 2-4).
(2)
Withdraw
receptacle.
