TM 9-2330-376-14&P
Section III.
OPERATOR
MAINTENANCE
PROCEDURES
Page
Number
Paragraph Title
Cleaning Air Coupling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cleaning Electrical Connector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Handbrake Lever Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Servicing Air Reservoir . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-6. GENERAL.
The following paragraphs contain those maintenance procedures to be performed by the operator/crew. lf a
problem with the equipment is discovered that cannot be corrected, notify your supervisor.
3-7. CLEANING ELECTRICAL CONNECTOR.
a. Use a cleaning cloth (Item 4, Appendix E) to remove any buildup of grease, dirt, etc.
WARNING
Dry cleanlng solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent's flash point is 100F-138F (38C-59C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
dry cleaning solvent (Item 14, Appendix E) to thoroughly
clean connector (1).
c. Allow connector (1) to dry.
3-12