TM 9-2330-376-14&P
Section
Il.
SERVICE
UPON
RECEIPT
Page
Number
Paragraph Title
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Servicing Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-4. GENERAL.
When an XM979, XM1061, M1061A1, or XM1073 trailer is received by the using unit, determine whether it has
been properly prepared for service and is in condition to perform its mission. Follow the instructions in paragraphs 4-5
and 4-6.
4-5. INSPECTION INSTRUCTIONS.
a. Read and follow all instructions on DD Form 1397.
b. Remove any metal strapping, plywood, tapes, seals, wrapping, or any other shipping material.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent's flash point is 100F-138F (38C-59C). if you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
c. If any exterior parts are coated with rust preventive compound, remove with dry cleaning solvent (item 14,
d. Inspect equipment for damage incurred during shipping.
e. Check equipment against packing slip to see if shipment is complete. Report all discrepancies in
accordance with instructions in DA Pam 738-750.
4-6.
SERVICING
INSTRUCTIONS.
a. Perform all operator/crew and organizational PMCS. Schedule the next PMCS on DD Form 314.
b. Perform all lubrication regardless of interval (Chapter 3, Section l).
c. If any system of the trailer does not operate properly, refer to troubleshooting instructions in Chapter 3,
d. Report ail problems on DA Form 2404.
e. Perform a break-in road test of 25 mi (40 km) at a maximum speed of 50 mi/h (80 km/h).
4-2
