TM 9-2330-381-14
2-27.
DUAL WINCH LOADING AND UNLOADING (CONT)
(p) When passenger side winch cable (24) reaches front of platform, release AUXILIARY WINCH lever (31).
Route passenger side winch cable (24) through gooseneck cable guide (34). Push down on AUXILIARY
WINCH lever (31) and continue to pull passenger winch cable (24) to auxiliary snatch block (17).
(q) Release AUXILIARY WINCH lever (31) when passenger side winch cable (24) is approximately 12 inches
(29 cm) from auxiliary snatch block (17). Spotter must continue to pull passenger side winch cable (24)
until winch cable has enough slack that it touches the ground.
(r) Remove cotter pin (28) and shouldered pin (29) from auxiliary winch cable clevis (30). Separate auxiliary
winch cable (13) from passenger side winch cable (24). Lay passenger side winch cable (24) on the
ground in front of payload.
(s) Release AUXILIARY WINCH KICKOUT by lifting and rotating lever (10) counterclockwise.
(t) Pull auxiliary winch cable (13) forward over platform and along streetside of gooseneck toward drivers
side of winching station on tractor.
(u) Pull DRIVERS SIDE WINCH lever (35) upward momentarily until there is enough slack in drivers side
winch cable (36) to be removed from stow hook (25). Move clevis on winch cable (36) off of stow hook
(25) to unstow winch cable. Continue paying out cable (36) until spotter on the ground can reach clevis.
Release lever (35).
(v) Remove and retain cotter pin (26) and shouldered pin (27) from clevis on drivers side winch cable (36).
Install auxiliary winch cable clevis (30) over one ear of clevis on drivers side winch cable (36) and install
shouldered pin (29) and cotter pin (28).
(w) Engage AUXILIARY WINCH KICKOUT by lifting and rotating lever (10) clockwise. Disengage DRIVERS
SIDE WINCH KICKOUT (20) switch by pulling switch.
WARNING
Do not allow auxiliary winch cable to cross itself or knot up on winch or injury to
personnel my result.
(x) Using one person to operate winch controls and a second person to make sure that winch cable clevises
do not hang up on platform, push down on AUXILIARY WINCH lever (31) to pull drivers side winch cable
(36) to auxiliary snatch block (17).
(y) If auxiliary winch cable (13) does not pull drivers side winch cable (36), push ENGINE SPEED CONTROL
switch (32) to HIGH ENGINE IDLE. Momentarily push ENGINE SPEED CONTROL switch (33) to lock
engine speed at high idle (approximately 1500 rpm), and then release switch.
2-132
