TM 9-2330-381-14
(z) When drivers side winch cable (36) reaches front of platform, release AUXILIARY WINCH lever (31).
Route drivers side winch cable (36) through gooseneck cable guide (34). Push down on AUXILIARY
WINCH lever (31) and continue to pull drivers side winch cable (36) to auxiliary snatch block (17).
(aa) Release AUXILIARY WINCH lever (31) when drivers side winch cable (36) is approximately 12 inches (30
cm) from auxiliary snatch block (17). Spotter must continue to pull drivers side winch cable (36) until
winch cable has enough slack that it touches the ground.
(ab) Remove cotter pin (28) and shouldered pin (29) from auxiliary winch cable clevis (30). Separate auxiliary
winch cable (13) from drivers side winch cable (36). Lay drivers side winch cable (36) on the ground in
front of payload. Install shouldered pin (29) and cotter pin (28) into auxiliary winch cable clevis (30).
(ac) Restow snatch block and auxiliary winch cable as follows:
1. Unscrew retainer bolt (18) and rotate side housing (19) on auxiliary snatch block (17) to open snatch
block.
2. Remove auxiliary winch cable (13) from auxiliary snatch block (17), rotate side housing (19) to close,
and tighten retainer bolt (18) to secure side housing in closed position.
3. Remove auxiliary snatch block (17) from shackle (12.1) and place back into storage on M1070
tractor.
3.1 Remove two small shackles (12.1) from larger shackles (11) in upper, left and right recovery eyes.
Return smaller shackles to BII.
Change 1 2-133
