TM 9-2330-381-14
4-25.
VEHICULAR BAR LAMP (CONT)
ASSEMBLY
NOTE
If installing new vehicular bar lamp, the four mounting holes must be drilled out to
0.200-0.211 inch (0.508-0.535 cm) diameter.
1.
Aline and install, by turning and/or twisting, marker clearance lights (7) onto vehicular bar lamp (6).
2.
Aline and install vehicular bar lamp (6) to platform. Secure using four lockwashers (5) and screws (4).
3.
Reconnect terminal lug (3) on white wire (ground) to platform using screw (2).
4.
Using semitrailer electrical schematic (figure FO-1) as a guide, reconnect socket connector (1) to W2 harness.
FOLLOW-ON MAINTENANCE
Reconnect intervehicular electrical cable, turn on tractor/semitrailer lights, and check vehicular bar lamp for proper
operation (para. 2-24).
4-26.
STOP LIGHT/TAIL LIGHT
This task covers:
a. Disassembly
b. Inspection
c.
Assembly
INITIAL SETUP
Tools
Equipment Condition
General mechanics tool kit,
Semitrailer parked on level ground,
item 16, appx. B
parking brakes applied, and
Electrical repair kit,
intervehicular cables disconnected
item 18, appx. B
Materials/Parts
Wiping rag, item 19, appx. E
Electrical insulation sleeving,
Locknut (3)
item 22.2, appx. E
Electrical insulation sleeving,
item 22.1, appx. E
NOTE
The following procedure is to be used for either the curbside or streetside stop
light/tail light. To repair or replace both lights, repeat this procedure as necessary.
4-108 Change 3
