TM 9-2330-381-14
3.
To install either curbside or streetside rear red reflector assemblies (4), position reflector (4) on access cover (6),
aline mounting holes, and secure with two screws (3) and locknuts (2). Assemble access cover (6) to deflector (5)
4-75. DATA PLATES, DECALS, AND STENCILS
This task covers:
a. Removal
b. Cleaning
c. Installation
INITIAL SETUP
Tools
General mechanics tool kit, item 16, appx. B
The following tools can be found in common tool kit no. 1, item 17, appx. B:
Gloves, chemical and oil
Stencil brush
protective
Stencil set
Goggles, industrial
Riveter, blind, hand
Materials/Parts
Technical alcohol, item 1,
Rivet (4)
Rivet (5)
Wiping rag, item 19, appx. E
Rivet (2)
Dry cleaning solvent, item 26,
Locknut (2)
Locknut (4)
Tape, double-sided, item 27.1,
Locknut (4)
Locknut (10)
Rivet (4)
Locknut (4)
Rivet (4)
Washer
Equipment Condition
Tractor/semitrailer uncoupled (para. 2-24)
Gooseneck lowered to lowest position, if uncoupled (para. 2-18)
Platform adjusted to 43 inch height (109 cm) (para. 2-19)
General Safety Instructions
WARNING
Dry cleaning solvent (PD-680, Type III) is used to clean parts and is potentially
dangerous to personnel and property. Extinguish all smoking materials and do not
allow sparks or open flame near the work area. Use skin and eye protection and
work in a well-ventilated area. Flash point of dry cleaning solvent is 200F (93C).
Drilling operations are hazardous to the eyes. Always wear eye protection when
drilling or injury to personnel may result.
Change 1 4-349
