TM 9-2330-381-14
4-92.
PLATFORM SUSPENSION HYDRAULICS (CONT)
11.
At streetside #3 bogie, tag and remove two tubes (38 and 39) and elbows (40).
Install caps/plugs into all
openings.
12.
At streetside #4 bogie, tag and remove three tubes (41, 42, and 43), elbow (44), tube (45), coupling nut (46),
reducer (47), and tee (48). Install caps/plugs into all openings.
13.
At streetside #5 bogie, tag and remove two tubes (49 and 50). Install caps/plugs into all openings.
14.
Just aft of each bogie, curbside and streetside, remove two straight adapters (51) and preformed packings (52)
from suspension isolation valve assembly (53). Remove two nuts (54), nipples (55), preformed packings (56),
and suspension isolation valve assembly (53). Remove three self-locking nuts (57), washers (58), and T bracket
(59). Install caps/plugs into all openings. Discard preformed packings and self-locking nuts.
15.
At curbside front, remove four screws (60) and two block clamps (61).
16.
Tag and remove three tubes (62, 63, and 64), coupling nut (65), reducer (66), and tee (67). Install caps/plugs into
all openings.
17.
Remove reducer (68), tube nipple (69), nut (70), and preformed packing (71). Install caps/plugs into all openings.
Discard preformed packing.
4-452
