TM 9-2330-384-14&P
5-5. GRABHANDLE AND CONVOY WARNING LIGHT CABLE ASSEMBLY
REPAIR (Con't).
b. CONVOY WARNING LIGHT CABLE ASSEMBLY REPAIR
(1)
If installed, remove convoy warn-
ing light from mounting bracket
(10) (see paragraph 2-23).
(2)
Cut cable (6) at sleeves (9 and
12) and remove. Retain lockpin
(11) if not damaged.
(3)
Cut a length of cable (6) 10.75 in.
(27.3 cm) long.
(4)
Form a 1/2 in. (13.0 mm) loop in
one end of cable (6) and install
sleeve (12), Use vise grips to
crimp sleeve.
NOTE
Length of cable (8) and lockpin (11) assembly should be 13 in. (33.0 cm).
(5)
Form a loop at other end of cable (6) and install sleeve (9). Install lockpin (11) through loop
formed in cable. Pull loop tight. Use vise grips to crimp sleeve.
NOTE
Clip (7) should be positioned at overturn rail close enough to ensure that
lockpin (11) will reach mounting bracket (10).
(6)
Tack weld clip (7) to overturn rail to securely retain cable (6). Cable should not slip through
clip.
5-15
