TM 9-2330-384-14&P
5-6. CABINET REPLACEMENT (Con't).
(5)
Loosely install brace (26) and cabinet (7) with five bolts (24), ten washers (25), and five new
locknuts (28).
(6)
Loosely connect spare tire carrier (23) brace to cabinet (7) with two bolts (27), washers (30),
and new locknuts (29). Tighten locknuts (28 and 29).
(7)
Loosely connect rear brace (22) to spare tire carrier (23) with bolt (14), two washers (15),
and new locknut (21). Ensure brace is centered flush against pad at bottom rear corner of
cabinet (7).
(8)
Loosely connect front brace (20) to curbside framerail (19) with two bolts (16), washers
(17), and new locknuts (18). Ensure brace is centered flush against pad at bottom front
corner of cabinet (7).
NOTE
Refer to TM 9-237, Operator's Manual for Welding Theory and Application,
for proper welding procedures.
(9)
Weld front brace (20) and rear brace (22) to cabinet (7),
(10) Weld five clips for precheck tubing to rear wall and shelf of cabinet (7), as marked.
(11) Trim excess mylar tape.
(12) Fully tighten two locknuts (18) and locknut (21).
(13) Thread two cables (9) through straight adapters (6) into cabinet (7). Connect two tubings (4)
and tighten two nuts (5).
(14) Apply grease to two grommets (10). Install two tubing pieces (3 and 11) through grommets,
as marked.
5-21