TM 9-2330-386-14&P
4-22 WIRE CONNECTORS.
This task covers repair.
INITIAL SETUP
Equipment Condition
Tools
N o . 2 common tool kit
Connector disconnected.
Electrical connector tool kit
WARNING
Disconnect all electrical power before performing any
maintenance on the electrical system. Failure to do so
could result in injury.
NOTE
If necessary, slide marker bands away from the connector.
a.Male Connector Repair.
( 1 ) Slide shell (2) up wire lead (4) until clear of contact (3) and slotted
washer (1).
(2) Remove slotted washer (1).
(3) Slide shell (2) off over contact (3).
NOTE
If replacing shell only, skip steps (4), (5), and (7)
below.
(4) Cut wire lead (4) as close as possible to contact (3).
(5) Strip insulation from wire lead (4) equal to depth of new contact (3).
(6) Slide new shell (2) on wire lead (4).
(7) Slide wire lead (4) end in new
contact (3). Crimp contact to wire
lead. Apply insulating compound to
wire lead (4).
(8) place slotted washer (1) on wire
lead (4) at contact (3).
(9)Slide shell (2) down wire lead (4)
until slotted washer(1) seats.
4-34