TM 9-2330-386-14&P
4-21 WIRING HARNESSES(CONT) .
CAUTION
Be sure all grommets are present when installing wiring
h a r n e s s . If grommets are missing, the wiring harness may
be damaged.
S t a r t i n g a t r e a r o f s e m i t r a i l e r , route main wiring harness as recorded
(1)
d u r i n g r e m o v a l . P u l l main wiring harness through grommets located in
frame.
Secure main wiring harness in loop clamps by bending clamps against frame.
(2)
Connect main wiring harness leads to lights as listed below.
(3)
Para.
Composite lights (2)
Side clearance lights (4)
Bar light
Taillights (4)
At rear of semitrailer, install
(4)
t h r e e new tie straps on main
wiring harness at locations
noted during removal.
At 24-volt receptacle (9),
(5)
install main wiring harness
g r o u n d wire (8), lock washer
(7), and nut (6).
C o n n e c t main wiring harness
(6)
leads to 12- and 24-volt
receptacle harness connectors.
h. Testing.
( 1 ) Guide wires and tubing into frame opening and position nose plate (2)
against frame.
(2) Install and tighten four capscrews (1).
(3) Connect electrical power and test for proper operation.
TASK ENDS HERE
4-33