TM 9-2330-386-14&P
5-9 KINGPIN (CONT) .
( 4 ) TO c e n t e r t h e k i n g p i n ( 4 ) , m e a s u r e t h e d i s t a n c e from the chalk mark to the
c e n t e r of the hub cap plugs on the front axle (A and B). The difference
b e t w e e n measurements should be no more than 3/8 inch.
(5) If the measurements are not correct, adjust position of kingpin (4) on
bolster plate (5) until measurements are within limits.
WARNING
W e a r welding mask, gloves, and apron when welding or
using cutting torch. Failure to wear adequate protective
clothing may result in serious injury.
5-12