TM 9-2330-386-14&P
5-10 SPRINGS (CONT).
(2) Install two U-bolts (15) in trunnion hub (14).
( 3 ) Slide trunnion hub (14) with two U-bolts (15) on trunnion tube (19).
( 4 ) Repeat steps (1) through (3) at opposite end of trunnion tube (19).
( 5 ) Position spring (13) on axle alinement plates (18). Be sure the recessed
areas (20) on the underside of both spring ends are alined with the raised
s u r f a c e of the alinement plates (18).
( 6 ) Position trunnion hub (4) on both springs (13).
( 7 ) Install two pads (12) with rounded edges on spring (13). Install end
cap (11).
5-15
