TM 9-2330-388-14
e.
Push compression release lever on top of engine
toward the rear of the trailer and hold, Fig. 2-12.
f.
While holding down compression release lever,
give the rope a smooth, fast pull.
g.
When engine is up to speed, after a couple of
revolutions, release compression release lever.
h.
If Alt or oil pressure lights remain on, stop unit
and refer to Unit Maintenance.
CAUTION
Make sure to prime pump within two minutes
of
starting
engine,
otherwise
pump
mechanical seal can be damaged.
8.
Open discharge valve. Shut unit off if pump is
not delivering water within two minutes of ignition.
Figure 2-11. Rope Starting
2-13
Cold Starting
Figure 2-13. Cold Weather Oil Add Hole
Figure 2-12. Activating Compression Release Lever
At low temperatures it is advisable to operate as follows:
Remove the rubber plug; insert in the hole about three
WARNING
cubic centimeters of same type engine oil (1/4 ounce or
1.5 teaspoons); reinsert the plug and start engine, fig. 2-
Compression release relieves a heavy load
13.
on the starter while cranking.
IT IS
THEREFORE MANDATORY TO USE THE
COMPRESSION
RELEASE
WHENEVER
STARTING.
2-9