TM 9-2330-388-14
(3) Disconnect tubing from fitting and remove
(5) Trim ends of tubing to get a smooth, square
the insert, compression sleeve and nut on both ends
cut. Slide tubing nut on end of tube. Slide compression
tubing. Release the clips and pull tubing through
sleeve over end of tubing. Install tubing insert. Connect
grommets.
tubing to adapter fitting and tighten tubing nut securely.
Do the same procedure on both ends.
NOTE
(6) Check replaced tubing for leaks. No leaks
are permitted.
Tubing is stocked in bulk lengths. Measure
original tubing and cut new tubing to same
(7) Remove blocking from semitrailer wheel.
length.
d.
Air Line Fittings. Use antiseize tape (item 28,
(4) Install tubing on semitrailer and bend clips
down securely to hold tubing in position.
let any of the tape get into the system.
4-120