TM 9-2330-388-14
(d) Install outer wheel bearing cone in hub.
the hub cap to the hub. Remove hub cap and gasket.
(c) Using wheel bearing nut wrench move outer
(e) Install inner bearing nut, lock ring, wheel
wheel bearing nut, wheel bearing was lock ring, and
bearing washer, and outer wheel bearing nut, but do not
inner wheel bearing nut.
tighten.
(d) Remove outer wheel bearing cone
(f)
Install wheels and tires and adjust wheel
hearings.
(e) Remove hub and drum from axle spindle
being careful not to damage seal.
4-52.
Tire and Tube
a.
Service. Gage tires for correct pressure. For
studs from hub and drum.
hard surface roads, inflate to 70 psi; for cross-country
and sand, inflate to 35 psi.
b.
Inspection. Remove objects such as nails or
(a) Install studs (short side from shoulder
glass. Check for apparent loss of air, unusual wear, or
facing out) into hub and drum and secure studs
missing valve caps. Replace as required.
lockwashers and nuts.
Repair.
Refer to TM 9-2610-200-24 for
c.
(b) Install hub and drum onto axle spindle.
instructions on dismounting, repair, and mounting of tire
and tube on rim.
(c) Pack bearing from large end of cone
cavities between rollers and cup are filled.
4-126