TM 9-2330-388-14
(1) Remove locknut (5) and remove fill cover
(2) Install gasket (6) and vent (8) to fill cover
(7), adjusting bolt (14), and spring (15).
(7).
(2) Remove vent (8) and gasket (6) from cover
(3) Install assembled fill cover to manhole (9)
(7). If gummed up with product, or if there signs of
using adjusting bolt (14), spring (15), and locknut (5).
obvious damage, replace vent.
(4) Adjust (step a).
(3) Using a punch and hammer, drive pin (11)
from safety latch (13). Remove spring (12).
e.
Installation.
d.
Assembly.
(1) Position manhole cover gasket (10). Set
manhole cover (9) in place and retain with clamp (4).
(1) Position safety latch (13) and spring (12)
manhole cover (9). Install pin (11). Peen end of pin to
(2) Secure clamp with bolt (1), washer (2), and
cure safety latch to manhole cover.
nut (3).
Section XIX. MAINTENANCE OF BODY ACCESSORY ITEMS
4-66.
Identification and Instruction Plates, Para 1-9.
4-63.
Bulk Transfer Hose Assembly
a.
Removal. Remove retainer clips from hose
NOTE
retainers, slide bar aside, and remove hose from trout
Some instruction plates have been mounted
with rivets. Drill rivets out and replace with
proper machine screw.
b.
Installation. Put hose in trough, move bar into
position, and attach retainer clip.
a.
Removal.
Remove screws holding plates to
semitrailer.
4-64.
Water Level Cage
b.
Installation.
Fasten new plates to semitrailer
If wooden fuel gage is unreadable or broken, replace. If
with screws.
cap, chain, or storage tube is missing or damaged,
replace.
4-67.
Fire Extinguisher Mounting Bracket.
4-65.
a.
Service. Check tightness of mounting bolts and
for damage to retainer bracket.
General. Reflectors are located on the front,
a.
near the marker lights, and on both ends of the hose
b.
Replacement.
trough
(1) Remove
protective
cover
and
fire
b.
Replacement.
extinguisher.
(1) Remove old reflector off semitrailer. Clean
(2) Remove four self-locking nuts, flatwashers
surface thoroughly.
and capscrews. Remove mounting bracket.
(2) Place new reflector in position.
(3) Install new mounting bracket and fasten
with four capscrews, flatwashers, and self-locking nuts.
(4) Install fire extinguisher and protective cover.
4-135
