TM 9-2330-388-14
b.
Column 2, Component/Assembly. Column 2
e.
Column 5, Tools and Equipment. Column 5
contains the names of components, assemblies,
specifies, by code, those common tools sets (not
subassemblies, and modules for which maintenance is
individual tools) and special tools, TMDE, and support
authorized.
equipment required to perform the designated function.
c.
Column 3, Maintenance Function. Column the
f.
Column 6, Remarks. This column shall, when
functions to be performed on the item listed in Column 2.
applicable, contain a letter code, in alphabetic order,
(For a detailed explanation of these functions, see para
which shall be keyed to the remarks contained in Section
d.
Column 4, Maintenance Level.
Column 4
B-4.
Explanation of Columns in Tool and Test
specifies, by the listing of a work time figure in the
Equipment Requirements, Section III
appropriate subcolumn(s), the level of maintenance
authorized to perform the function listed in Column 3.
a.
Column 1, Tool or Test Equipment Reference
This represents the active time required to perform
Code. The tool and test equipment reference code
maintenance function at the indicated level of
correlates with a code used in the MAC, Section II,
maintenance. If the number or complexity of the tasks
Column 5.
the listed maintenance function vary at different
maintenance levels. appropriate work time figures w
b.
Column 2, Maintenance Level. The lowest level
shown for each level. The work time figure represents
of maintenance authorized to use the tool or test
the average time required to restore and item (assembly,
equipment.
subassembly, component, module, end item, or system)
to a serviceable condition under typical operating
c.
Column 3, Nomenclature. Name or Identification
conditions.
This time includes preparation time
of the tool or test equipment.
(including any necessary disassembly/assembly time),
troubleshooting/fault
location
time,
and
quality
d.
Column 4, National/NATO Stock Number. The
assurance/quality control time in addition to the required
National or NATO Stock Number of the tool or test
to perform the specific tasks identified for maintenance
equipment.
functions authorized in the Maintenance Allocation Chart.
The symbol designations for the various maintenance
e.
Column 5, Tool Number.
The manufacturer's
levels are as follows:
part number
C ................
Operator or Crew
B-5.
Explanation of Columns in Remarks, Section
O................
Unit Maintenance
F ................
Direct Support Maintenance
H ................
General Support Maintenance
a.
Column 1, Reference 4 Code.
The code
recorded in Column 6 Section II.
b.
Column 2, Remarks.
This column lists
information pertinent to the maintenance function being
performed as indicated in the MAC, Section II.
Section II. MAINTENANCE ALLOCATION CHART
(1)
(2)
(3)
(4)
(5)
(6)
MAINTENANCE LEVEL
GROUP
MAINTENANCE
GS Depot TOOLS AND
UNIT
DS
NUMBER
COMPONENT ASSEMBLY
FUNCTION
C
O
F
HD
EQUIPMENT
REMARKS
06
ELECTRICAL SYSTEM
0607
Instrument or Engine
Control panel
Wiring, Switches,
Inspect
0.3
Decals, Connectors,
Replace
0.5
Conduits, Etc.
Repair
0.5
B-2
