TM 9-2330-388-14
10.
Connect battery cables carefully observing
incident while the engine is running could
polarity. Positive cable is installed first and goes to
damage the food grade seal in the pump.
connection starter.
14.
Test run and check for leaks.
11.
Connect
upper
red
alternator-to-voltage
regulator wire at voltage regulator.
CAUTION
Make sure water is flowing through the pump
12.
Install rear panel on cabinet with six screws.
within two minutes of starting dispensing
unit engine, otherwise pump mechanical seal
13.
Open emergency valve and discharge valve and
can be damaged. Open discharge valve to
unit discharge until stream runs normal.
check.
CAUTION
15.
Prior to placing the pump back into service, it
Water must run normally to avoid a fluid
must be cleaned and sanitized. Cleaning is described in
stoppage caused by air pockets. Such an
7-11
