TM 9-2350-222-10-3
MAINTAIN TRACK (REMOVE END CONNECTORS) - Continued
N
O
T
E
When using end connector puller (K), do steps 5 and
6 and skip steps 7 thru 10. When using hydraulic end
connector puller and pump, skip steps 5 and 6 and do
steps 7 thru 10.
5.
Place end connector
puller (K) on end connec-
tor (M).
NOTE
It may be necessary to hit seated end connec-
tor (M), with hammer, to loosen.
6. Using 1-1/2 inch socket (B) and ratchet (E) with 3/4 inch drive,
evenly tighten two puller screws (T). Tighten until about 1
inch of track pins (U) shows behind end connector (M).
TA132896
3-66
