TM 9-2350-222-10-3
MAINTAIN TRACK (INSTALL END CONNECTORS) - Continued
2. Using hammer (C), tap end connector (E) onto link pins (F) until it touches
track fixture (D).
3. Turn track fixture (D) clockwise until loose. Remove from track.
4. Using hammer (C), pound end connector entirely onto pins until it hits
track (G).
5. Set wedge (H) in end connector (E).
NOTE
If organizational mechanic is available, have him
torque bolt (J). If organizational mechanic is not
available, tighten bolt tightly. Have organizational
mechanic torque bolt (J) as soon as possible.
6. Using T-handle (B) and 15/16
inch socket (A), tighten bolt
(J) by turning clockwise.
7. Return tools to stowage,
TA132907
3-77
